The
Samsung Galaxy A50 runs on Android v9.0 (Pie)
operating system. The device is powered by Octa core (2.3 GHz, Quad
core, Cortex A73 + 1.7 GHz, Quad core, Cortex A53) processor paired with
4 GB of RAM. As far as the battery is concerned it has 4000 mAh. Over
that, as far as the rear camera is concerned this mobile has a 25MP +
5MP + 8MP camera . Other sensors include Light sensor, Proximity sensor,
Accelerometer. So, does it have a fingerprint sensor? Yes, it does. For
graphical performance that can make games run smoothly, this phone has
got a Mali-G72 MP3 GPU. On board storage is at 64 GB with the option to
expand the memory by Yes Up to 512 GB.
Here, You will find out the Samsung Galaxy A50 SM-A505 Frp Bypass Combination Firmware download link and install guideline. Also in addition page from
this, all the information related to this firmware flash file is
described here. We've provide the USB driver and flash tool to
install this smartphone in this page.
Download's
Steps to Remove Frp SM-A505 on Z3x:
Steps to Install Samsung Galaxy A50 SM-A505 COMBINATION Firmware on ODIN:
Download's
Steps to Remove Frp SM-A505 on Z3x:
- Open the Z3x or flashing the Samsung device.
- Choose the model number of your device from Z3x to SM-A505.
- Connect your SM-A505 with computer.
- From the selection of the FRP tab using your Z3x or Samsung-related flashing device.
- Get ADB to enable notice after connecting your device.
- Select ADB in debug mode from your mobile
- Press the FRP Removal button and wait
- After the FRP automatically reboots your device
- After rebooting, configure your device and enjoy your Samsung device.
Steps to Install Samsung Galaxy A50 SM-A505 COMBINATION Firmware on ODIN:
- Download & extract and unzip the firmware on your computer.
- Double Click on Odin flash tool, (Right click on Run as Administrator).
- Boot into your Samsung device download mode. Power off the your device then press and hold “Power button + Home button + Volume down button” together for about 10 – 15 seconds.
- Press the “Volume Up” key to navigate to Odin Download mode.The window will change to another one that displaying “Downloading” and “Do not turn off target!!”.
- Connect your smart mobile device to the computer using a Good USB cable. The flash tool will detect your device automatically and will display a message as added in the left lower white In the area.
- Click on “PDA” or “AP” button.
- Select firmware file “Start” button to continue the procedure. Do not disconnect or operate device while process.
- After flashing successful, this tool will display you a green color button as “Pass”. This message may depend on your application edition.