Winstar W305 Flash File 6531E 100% Tested

You are searching Winstar W305 SC6531E New 2020 Vesion Flash File? You come in the right place. Using this Winstar W305 flash file, you can flash the firmware file to any software issues or problems on your device. Yes! With this guide, you can resolve problems such as Pin remove/unlock, Full flash, Dead recovery, As can be seen Automatically restart phone and more also fix any software related problems.

To flash the firmware file on your Winstar W305 keypad mobile device, we are using the Miracle Thunder as this device is powered by SCR. We have shared all the requirement files to download and install the firmware on your device.


Winstar W305 Flash File 2020




This Flash File Reading with CM2 (Chinese Miracle)


Wait for device ...

Device Connected!
BootVersion : SPRD3
BootSource  :  InternalLibrary
BootVersion : Infinity SCR 6531EFM v1.1 (c)2019
Port speed : 921600
FDL Flash  : Control transfered!

Boot Done!

CS0_MEM : SPI : [WINBOND] : W25Q32 : 0x00400000 [ 4MiB ]

Read Ok, 4194304 bytes

Saved to : C:\Users\rkMobile\Desktop\winstar w305 flash file\SC6531E_SPI_WINBOND_W25Q_4MiB.bin

100% OK ✅ ✅ ✅




Download Winstar W305 Flash File Firmware


File Name: Winstar W305
Processor: SC6531E
File Type: Bin
File Size: 4MB
Status: New 2020 Version


Download Winstar W305 SC6531E Flash File-2020


Need also:



How to Flash


Before installing the Firmware on your Winstar W305, you should download the firmware flash file. Then download and install the USB Driver and Flash tool on the PC as well. Once you’re done with these, you can proceed to the steps below. But let’s take a quick look at the Firmware importance and firmware details above.



Step to Flash Winstar W305

Following below steps to flash your Winstar W305 mobile phone using CM2/Miracle or other’s flash tools. Also We have shared a short tutorial of Miracle Thunder Tool.

  1. Download and extract the flash file on your computer.
  2. Install the USB Driver on your computer.
  3. Lunch tool on your PC screen
  4. Select SPD
  5. Choose 6631E SP
  6. Add file on the tool
  7. Click the Start button.
  8. Connect your device to computer via USB cable
  9. Insert battery in mobile.

That’s it, guys. We hope that you’ve installed the Stock Firmware on your Firmware device successfully. And, if we don’t work with this guide. Then do it in the comments section below

Post a Comment

Previous Post Next Post